Merge collector and 1.6 Miata flywheel

I'm tired of tripping over these.

Edelbrock slip-on merge collector. 1.75" primaries, 3" outlet. Ti-TECH coating, which kinda looks like grey paint to me but is obviously much more exotic. I'm sure I read they use this on the Space Shuttle or something. Usually sold in pairs, but I used the other one to make a header for a four-cylinder. $35 plus shipping.

1.6 Miata flywheel from Fidanza. Will fit any 1990-05 Miata as long as you use a 1.6 clutch. 7.5 lbs, includes the pressure plate bolts. Perfect for autocrossers looking for the lightest rotating mass possible. It was engaging smoothly when I pulled it out of my wife's car. Despite appearances from the camera flash, it's not rusty. Suggested retail is $595 Today's special price is $75+ shipping, because I like you.

Also available: random 1998 Camaro Z28 bits (no, not the engine or drivetrain), a pair of refreshed Cadillac 427 heads, power window actuators from a Mazda 323 GTX, an MGB GT rear axle and springs and other exciting random things that I'll dig out soon.

When are you going to get tired of tripping over the Targa Miata?

You have pm

PM sent on the flywheel if no one has beaten me to it!

I think they're both spoken for. I'll let folks know if they become available again.

Sorry, Carson, I seem to have a lot of patience for that little thing

Same question as Carson but with "MGB GT donor car" :)

So I can now FMV my fidanza flywheel on the challenge car at $75. Cool!

Very nice!

Janel is now telling me I sold the flywheel too cheap Oh well, gotta do what I can to keep FMV low for the Challengers.