TurboFource said:They are glued in with high temp sealant
Then you should be fine.
TurboFource said:They are glued in with high temp sealant
Then you should be fine.
On the first try (not perfect but usable) we were able to print carbon fiber reinforced nylon seal holders using a $200 Ender 3 V2 printer.
Made a cardboard enclosure, used a dehumidifier to get humidity down to 30% in the room and a heater to get it over 80 degrees, also used a filament heater.
TPU
In reply to fidelity101 : what is TPU Fidelity?
You'll need to log in to post.
