NMNA
https://www.facebook.com/marketplace/item/782301512616395/
1968 Opel Kadett rolling chassis. All trim parts and front end components are in the car. No drivetrain. Would make a great engine swap candidate since it is very light! 1200 lbs as it sits. Need it gone. Make me an offer. Has a clean Title.
Ooohhh! Must have! But it’ll be gone long before I can make a trip down there 
In reply to 03Panther :
I was thinking about you after seeing this but only because I was wondering if you'd want the rusty Ranchero after I put it's drivetrain in this Opel. Lucky for me hobiercr ignored me when I asked if he could pick it up for me.
In reply to Stampie (FS) :
He'll pick it up for you, when do you want to get the ranchero?
In reply to EvanB (Forum Supporter) :
After he picks up the Opel.
Stampie (FS) said:In reply to 03Panther :
I was thinking about you after seeing this but only because I was wondering if you'd want the rusty Ranchero after I put it's drivetrain in this Opel. Lucky for me hobiercr ignored me when I asked if he could pick it up for me.
I was thinking that the 'ol 289/4speed would be perfect in that - just too far away!
Rather have that combo than the rust! but I have a 3800/5speed that would do the job as well.
Other than the cost of getting anything to Lower Ala'bam, I'm still sure you and I can do SOMETHING!
My F350 4x4 runs great, but the only trailer I can put a car on is an equipment trailer that is HEAVY. I only got 10 -11 on way out to get the 48 from John in KS; got the same with trailer loaded to the gills on the way back, though!
I do actually have a 13.5 foot single axle that Opel would fot on...
Some years ago, a car magazine (not GRM) put a SBC in one. Just sayin' .....
BTW: in case you don't FB, this one's only $200.
Just looked and it says it's SOLD.
drock25too said:Just looked and it says it's SOLD.
Sorry Evan but I tried.
Knew that couldn’t last long
You'll need to log in to post.
