Mr_Asa
SuperDork
11/29/20 5:32 p.m.
I'd like a certain type of shop trash can. I haven't found it out there on the interwebs, so I figured I'd whip up some designs in solidworks and go scrounging for some sheets of stainless steel so I can make my own.
I'd like something like this for the corners, but I'm having a hard time finding it out there. Thicker gauge steel would be ok

http://tri-guardsinc.com/72-x-3-x-3-90-deg-bullnose-14ga-type-304-satin-4-brushed-finish-stainless-steel-corner-guard/
Trash can will look something like:


Probably a long shot, but try to find a door off a junk stainless refrigerator. The corners are often shaped like that. Or possibly a shower grab bar cut in half lengthwise. New stainless is stupid expensive, but if you have a source for used/junk kitchen or bath accessories you can usually find something suitable. Or maybe some straight sections of stainless exhaust pipe?
Mr_Asa,
You might take a look at this site: https://www.stainlesssupply.com/corner-guards/docs/corner-guards.php?sc1=36
They have up to 14ga and a variety of widths/lengths and other options. Might not be as rounded as you are looking for , but you might find something that works. 