Forums » Grassroots Motorsports »

Machining cast iron

1 2
96DXCivic
96DXCivic HalfDork
3/3/10 5:26 p.m.

I have the dimensions and every thing nailed down. We have a brake dyno which we are planning on running some testing on. So the rotors we get are for testing only.

1 2

You'll need to log in to post.

More like this

Tire Test: Is the value-priced X Comp H/P a 200tw contender?

How to improve aerodynamics with a virtual wind tunnel

Want to go wheel-to-wheel? SCCA Race Experience is a good start.

Tracks visited once but sadly never again

10 lessons to keep your race effort disciplined

3D printing: What you need to know to get started

If it's so easy to get on track, why is it so hard to get a car?

What’s faster than a McLaren Senna? This Ford Mustang Shelby GT500.

The high-tech lessons you can learn from historic race cars

$2000 Challenge: Plenty of big prizes up for grabs
Our Preferred Partners
Koni GRM
HMS Motorsport
SCCA
Tire Rack GRM
Holley
IMSA
Intercity Lines GRM
Sunoco GRM
Weathertech
HPX Show GRM
AutoBidMaster
4Yc31vXXUaAWQbA5glLkUbEH7YW7JuntfLGRxdNcKtXPdzdZRj32Xe2lCxqq1UYX