Ashyukun (Robert)
Ashyukun (Robert) GRM+ Memberand UberDork
9/3/20 9:48 a.m.

I have a bad habit of picking up parts for projects that just never end up happening and thus the parts, still new in box, just end up sitting around unused when I sell the vehicle. I figured I'd break these out from the other post since they're a bit different in nature. There's little rhyme or reason to the parts here other than they were all picked up for vehicles that we no longer own. Everything is located in Lexington, KY.  Prices are for pickup here or working out a relay via nearby GRMers to get to you, but pretty much all of these parts are small and light enough to mail so if you want something mailed I'll have to figure out the postage to get you a final price. 

I'll try and sort things by what vehicle they were originally picked up for as well as list what other applications they may have (pulled from Rock Auto's info for the parts). I'm just going to list the oil filters by their numbers as they have lots of vehicles they fit.

2000 Chevy Blazer (4.3L Vortec 4300 V6)

4.3L V6 Head Gasket Replacement Kit: 2x Felpro 9354 PT-1 Head Gaskets, 2x Felpro ES74034 Head Bolt Sets- $20. Should work on most any vehicle that uses the GM 4.3L Vortec engine from 1985-2001, though the head bolt set says 1996-1998 RA says it fits all the 4.3L V6's (click on the part # on this page for the full list)

SU109TG Coolant Temperature Sensor- $2. Seems to fit like most every GM vehicle from the 80's through 200X and a few others like Hondas/Acuras, and also this particular part number doesn't seem to be made anymore. Link to the current parts available

AC Delco D448X distributor rotor- $2. Should fit pretty much any of the 4.3L V6's like the above head gaskets, details here

1988 Mazda RX-7

Mazda OEM M507-17-335A Main/Output Shaft Seal- $5. Fits all 2nd Gen RX-7's AND pretty much all Miatas, see here.

Mazda OEM 0603-16-103 input shaft seal- $5. Fits a surprising number of other vehicles, see here.

Flywheel Stopper- $10. Not new, but figured I'd put it here with the car anyway. Bolts to the housing to lock the flywheel in place when working on the engine, fits non-turbo 13Bs. Includes bolts.

 

2000 Saturn S-series

Duralast TPS163 Throttle Position Sensor- $5 (fits 2000-2002 Saturn S-series)

Duralast ES3238 Tie Rod End- $2 - For application, see here

 

2008 Mercury Mariner/Ford Escape/Mazda Tribute

Dorman 604-224, 2x Dorman 604-241 Heater Blend Door Actuators- $5 each. IIRC, the -224 controls the mix of hot/cold air and the -241 controls the mode/where the air goes. Used by late 2000's Escapes and derivatives and some F-series trucks.

 

1998 Buick Riviera

Stant 13848 Thermostat- $1, Applications besides the Riviera here.

Prime Choice 513121 Hub/Wheel Bearing assembly- $10. Fits the larger FWD GM cars (see below)

BUICK CENTURY 1997-2001
BUICK LESABRE 2000-2001
BUICK PARK AVENUE 1997-2001
BUICK REGAL 1997-2001
BUICK RENDEZVOUS 2002-2006
BUICK RIVIERA 1997-1999
CADILLAC DEVILLE 1997-2001
CADILLAC ELDORADO 1997-2001
CADILLAC SEVILLE 1997-2001
CHEVROLET IMPALA 2000-2001
CHEVROLET MONTE CARLO 2000-2001
CHEVROLET VENTURE 1997-2004
OLDSMOBILE AURORA 1997-1999
OLDSMOBILE INTRIGUE 1998-2001
OLDSMOBILE SILHOUETTE 1997-2004
PONTIAC AZTEK 2001-2005
PONTIAC BONNEVILLE 2000-2001
PONTIAC GRAND PRIX 1997-2001
PONTIAC MONTANA 1999-2004
PONTIAC TRANS SPORT 1998

2008 Jeep Patriot (I'm morally required to tell you to never, ever buy one of these POS's)

2x AC Delco 46A0940A Tie Rod Ends- $5 each. Details and application to other, less crappy vehicles here.

 

2001 Buick Park Avenue Ultra

AC Delco 45G10035 Stabilizer Bar Link Kit- $5. Applications to other vehicles can be found here.

 

Oil Filters- $1 each

  • STP S3980 (think this was from the El Camino's 350)
  • Bosch 3330 (details here, probably got for the Patriot)
  • Bosch 3312 (details here, fits the FC RX-7)
03Panther
03Panther HalfDork
9/3/20 9:56 p.m.

I'm interested in the 4.3 stuff, but I'm not sure shipping to 36352 would be worth the effort?

Ashyukun (Robert)
Ashyukun (Robert) GRM+ Memberand UberDork
9/5/20 12:31 p.m.

In reply to 03Panther :

Well, the good news is that besides the head bolts it's pretty light. But the gaskets are on the larger side and I don't think they'll fit into any of the smaller one-price boxes. I can look around and see if I've got and appropriate-sized box for it and figure out what it would cost to mail it to you if you'd like.

You'll need to log in to post.

Our Preferred Partners
G3qRt9n2oU1QJWd0xCbIUgY92KD4fu1gSQyN7a4BNfTdMg4mVqYpezpqZNKonEgU