ford fuel tank parts???

anyone have a dead ford fuel tank that you can section out the part that the pump assb/ sender?

better photo of what i need  

I've got a tank for a OBS 250, but I'm about as far from ca as can be. Guess shipping wouldn't be bad though. Might take a week or two to figure out where I tossed it. Might be on a mates scrap area. 
He has a 2002 F450 tank that rusted inside - if it did not go in trash. 
Like I said, not a quick solution, but if ya have the time...

just need a 10 x 10 inch section.. with the hole in the middle

In reply to Alfaromeoguy :

Yea, shipping shouldn't be bad, if ya ain't in a hurry. 

i am 62... dont wait too long

the hole is about 125 mm diameter

any updates? thanks  but i do understand if you are in the upper midwest, or east coast..kinda cold there

Alfaromeoguy said:

any updates? thanks  but i do understand if you are in the upper midwest, or east coast..kinda cold there

If you were asking me, I'm just above the "other" L. A. (Lower Alabam') 

Im a bit W. of Dothan, AL, 'bout an hr n half N. of Panama City, FL. 
Haven't been out in the woods yet to look for my tank. I will ask my mate if he still has the 450 tank, tomorrow after church. 

In reply to 03Panther :

been in that area  a few years ago.. fly fishing...no wading.. heard of them gators, kept me out of the water

updates? thanks

thanks for the help, folks, but its been a few weeks now,,  will go to pick and pull and cut a section out of a tank..just wanted to get the tank done

proto typing the exhaust system

That's some impressive mocking up!

In reply to jfryjfry :

and cheaper than using steel exhaust tubing... mocks up fast.. thanks for the reply, cost 32$

relocated shifter handle.. a note.. when you dont have any cutting oil for you drill,,    olive oil works quite well